Webuser Forums: Problems with installing .NET Framework 2.0

I tried to download .NET Framework 2.0 via 'Automatic Updates'. It seemed to download OK, but it failed to install properly. From 'Add or Remove Programs' in 'Control Panel' I tried to carry out a repair of the installation. This lead to a dialogue box which said there was an error during set-up and gave a link which lead to site
http://support.microsoft.com/ph/8291- which in turn lead to this page:

http://support.microsoft.com/kb/306160/en-us?spid=8291&sid=global

How to repair an existing installation of the .NET Framework
View products that this article applies to.
Article ID : 306160
Last Review : December 3, 2007
Revision : 6.3
This article was previously published under Q306160
On This Page
SUMMARY
Steps to repair the .NET Framework installation
SUMMARY
You may need to repair your installation of the .NET Framework if you upgrade your operating system or if the current installation of the .NET Framework becomes corrupted. This article describes how to do so.

Back to the top
Steps to repair the .NET Framework installation
1. Obtain the original installation source. For example, if you installed the .NET Framework from a CD-ROM or from a DVD, insert that disc. If you downloaded the .NET Framework , download the .NET Framework again. Make sure that you click save to disk. If you installed the .NET Framework from a network share, reconnect to that share.
2. Click Start, click Run, type the following command, and then click OK:
N:\dotnetframework\dotnetfx.exe /t:c:\temp /c:"msiexec.exe /i c:\temp\netfx.msi REINSTALL=ALL ReinstallMODE=vomus"
Note Replace N:\ in this command syntax with the original installation path.

Important If you do not have a C:\temp folder on your computer, create one before you run this command.
The Microsoft Windows Installer will verify and repair the .NET Framework installation.

Back to the top
APPLIES TO
• Microsoft .NET Framework 2.0
• Microsoft .NET Framework 1.1
• Microsoft .NET Framework 1.0

I should be very grateful for advice. Is the above the solution the one I should be pursuing? And what does "Important If you do not have a C:\temp folder on your computer, create one before you run this command." mean - how do I find out if I have a C:\temp folder, and how do I create one if I do not? Also, from where can I download .NET Framework 2.0 to disc?

I have tried to uninstall the .NET Framework 2.0, but was again presented with a dialogue box saying there was an error during set up.

Further, 'Automatic Updates' keeps trying to install a Service Pack for .NET Framework 2.0. It seems to download OK but will not install.

As I say, I would be very grateful for advice for, as can be seen from my questions, I am fumbling round in the dark!!! I am running Xp Home.

Post Extras