Hi,

I have recently set up a BT Voyager 2100 3 PC network at home. The main PC is hard wired to the Voyager 2100 with a laptop using the PCMCIA receiver and another desktop using an internal PCI card. I think they are the 1060 and 1040 adaptors respectively.

My problem is the desktop using the PCI card suffers from loss of signal or poor signal strength most of the time. Its only about 12 ft away on the same floor level in the house. The laptop is OK wherever I use it.

Are there any specific settings that I can configure to boost the signal strength to the desktop PC such as exclusion of other signals, channel setings etc. I am picking up one other signal from a link.sys network and am not sure if thats a neighbours signal or not. I am a total novice at networking so any help would be most appreciated.

Regards & Thanks

Edited by moonbase on 19/12/2004 12:41 (server time).